![]() I am certain that the links specified on the card are configured correctly. LD1 on the probe does, however, flash 3 or 4 times when it is plugged into the USB port. I have searched the internet and this forum and I am completely out of ideas to try next.Īccording to the Getting Started card in the box an LED should flash, and when a button is pressed it changes. Its as if the development board is not compatible with the driver or the driver has a problem. I have tried the same on a Windows XP and Windows 7 PC and all report similar errors. I've combed through the datasheet and looked at other schematics for the same chip, but. In Device Manager, under the Universal Serial Bus controllers section I have an entry which shows as 'Unknown USB Device (Device Descriptor Request Failed), which is presumably the STLINK/V2 probe in the development board. I got myself an STM32F411RCT6 and my ST-Link V2 is not detecting it using SWD, but I am able to program other STM32s using an even simpler setup, so I think there is something specific about this MCU that I'm missing. ![]() The installation appears to succeed, however, when I plug in the development board via USB Windows complains with 'USB device not recognised'. Starting a drive cloning operation in MiniTool Partition Wizard (MTPW) is as simple as firing up the application, choosing Copy Disk Wizard in the left-hand menu (see Figure 1 background left. I am using a Windows 10 64-bit laptop with USB 3 ports and have installed the STLINK utility, en_stsw-link004.zip, which includes the relevent USB drivers. Note: STLINK-V3 boards can be recognized by Windows ® 10 without any driver installation. I have recently purchased a number of NUCLEO-L476 boards but cannot get the USB drivers to install correctly whch are required for both ther STLINK utility and also for System Workbench for STM32. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |